Jump to content
OGXbox.com

Hari125

Members
  • Posts

    44
  • Joined

  • Last visited

Posts posted by Hari125

  1. On 6/16/2018 at 6:40 AM, IAmADrunkGuy said:

    I was in the same boat looking for belts but didn't have time to wait, I didn't want to LOL.:P I went to dollar tree and bought the little rubber bands for girls hair. They seemed small but I figured I'd try and it worked LOL, They seem pretty thin so I put three on there and it works great. Probably wont last long but for $1 for 500 I cant complain!!!!

    IMG_7572.jpg

    Opening the drive will be a bit slower than with original belt, BUT it will work.

  2. 18 hours ago, KaosEngineer said:

    Take a #2 lead pencil and rub it on the conductive pad (now non-conductive after you cleaned it - removed the carbon) to add back conductive material where you removed it.  How well this fix works, ???  But, I've heard others have done so and it fixed their controller.

    Also i added a bit of metalic foil on the rubber. That way the A button is easier to press.

    image.thumb.png.2be5ce6ca458e3333f0f662892910169.png

    • Like 1
  3. 16 hours ago, KaosEngineer said:

    Take a #2 lead pencil and rub it on the conductive pad (now non-conductive after you cleaned it - removed the carbon) to add back conductive material where you removed it.  How well this fix works, ???  But, I've heard others have done so and it fixed their controller.

    You saved my life.

    I rubed pencil on the conductive pad where the A and X button are sitting and pasted some thin tape to secure the graphite. After that i closed the controller to test it and it worked! The X started working normally as before and the A (that was dead) started working TOO, but it needs a lot of pressure to work. I'm really thankfull that at least is working. Maybe i will end up buying the chungus duke controller (i like it).

     

    Here is how turned out:

    image.thumb.png.12d55889effddb9e762884910f2fdf21.png

    image.png.548006f5990ca3a678cf966819d8cec4.png

  4. Hi! I opened my xbox controller s to clean it with 95% alcohol and eventually cleaned the black part (where A,B,X,Y,black,white buttons are) with it. I didn't know it was touch digitizer ;-;

    After i assembled and tested it, the A and X buttons weren't working propertly. The X needed a lot of pressure to work and the A didn't worked at all. After 2 days the X button worked, but it still needs little pressure to work, but the A is like stone dead.

    Any suggestions? Are there any pins to short so i can simulate button push and eventually to add normal button to work as A.

  5. This is really bad. I was going to recomment you to follow the traces that were connected to the caps, remove a bit of the green layer that covers them and then soldering wires that are soldered to the caps, but the board is multilayer and it wont be easy to repair.

    I'm sorry to say it, but you are doomed. ;-;

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.