[Cannot Unlock Slave Hdd Using Chimp]

On 8/17/2020 at 7:11 AM, HDShadow said:

He confirmed that he had done that earlier.

There's something more going on here; if Chimp locked the HDD on that Xbox as slave (or master) it should be capable of being unlocked too.

The fact the 1TB HDD did not work as master and now can't be unlocked suggests either a connection or hardware problem. I'd check the 80 wire IDE cable is connected properly at all three points (HDD, DVD Drive, MB) as other have suggested. If that does not help then the best bet is trouble caused by the SATA/IDE adapter.

Unfortunately the only way to test that is try a new one and whilst you're at it a different 80 wire IDE cable too. If neither replacement helps then, even worse, the new HDD becomes the chief suspect. You could actually test that first if you have a spare HDD available and at least save the cost of buying a new SATA/IDE adapter.

I bought a pair of 80 wire IDE cables a few months ago and one of them works perfectly but when used the other had intermittent problems often reporting  errors 7 and 9 at boot. Connections all good and no obvious damage so initially I thought a HDD or SATA/IDE adapter fault too but it was the IDE cable causing the trouble.

I've had to dump it because of that.

I have tried a separate 80 wire IDE cable and 2 separate SATA/IDE adaptors, to no avail. When I attempt to unlock the drive via Chimp I get the same result no matter which option I choose, "hdtool: illegal option --d".

Is there a way to unlock this drive via PC to try again? I can't seem to get my pc to recognize the drive.

[Cannot Unlock Slave Hdd Using Chimp]

Hello,

I came across this site while searching for solutions to my problem. I was attempting to upgrade my XBOX HDD to a 1 TB WD SATA drive that is listed as lockable. I followed Mr. Mario's tutorial on Youtube to a T, and it appeared to be successful, however upon powering up with the new HDD in place of the old I get error 07 and on occasion 09. When going back and attempting to use Chimp to re-clone the original HDD to the new drive, the new drive cannot be altered due to it being locked. Attempts to unlock the HDD via the Unlock Slave Drive menu in Chimp do not work, all of which lead to the same screen referencing the password from the motherboard, but changing nothing. How do I unlock this drive?

And yes, I have the jumpers currently set to slave, and had them set to master when I attempted to utilize it as the master HDD.

Any help is appreciated.