Search the Community
Showing results for tags 'upgrade!'.
-
I hope this is the correct forum, apologies if not! I'm totally new to xbox modding and have watched videos and read as much as possible, but I've managed to screw up anyway unfortunately. I bought a hardmodded xbox with Xenium chip but stock hdd and so I used Hexen 2018 to install a 320Gb. I followed instructions, used Xb partitioner so that drive f used the rest of the available space etc. Once done and xbox rebooted, I'm only getting 123Gb available space on drive f! I was advised on another forum to redo it from scratch with Slayer's instead. Again once completed, it went back to only 123Gb available. I tried running xb partitioner again, go an error message 'LB48 not found' (I didn't get this error message the first time). I've tried re-doing it from scratch with Hexen 2018 again, same result even when I tried another hhd that's 250Gb, still only getting 123Gb. Any way to fix this, or should I give up and accept only getting 123Gb to use as at least it's still working now but if I mess about with it I may end up bricking it? (I softmodded my daughters xbox last week, that's working no probs. I'm awaiting a 500Gb hdd in the post, that I was planning to use Chimp to clone to and install, but now I'm anxious that I may have the same prob with that one as well!)
Board Life Status
Board startup date: April 23, 2017 12:45:48