whatitizz
-
Posts
5 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Store
Posts posted by whatitizz
-
-
It gets tighter. I wish I had a 3d printer now
-
2
-
-
On 3/14/2024 at 11:54 AM, SoftMachine said:
I'm not sure, you could try the Pico firmware and see. If there's an issue with that board, it would be routing for gpio 0 and 1 not being impedance matched, so if it doesn't work you could also try putting 27 or 22 ohm (or around that) resistors in series on the data +/- lines before the USB A host port and see if that helps
It worked without the resistors. I used Ver. 2.0 . I'm gonna try 3.0 next
-
2
-
-
On 3/14/2024 at 11:54 AM, SoftMachine said:
I'm not sure, you could try the Pico firmware and see. If there's an issue with that board, it would be routing for gpio 0 and 1 not being impedance matched, so if it doesn't work you could also try putting 27 or 22 ohm (or around that) resistors in series on the data +/- lines before the USB A host port and see if that helps
I'm gonna give it a shot and if not, I'll try the resistors. If all that fails, I'll look it what can be done with the source. By then though, I should have more picos. Thanks for your info
.
-
I'm out of Raspberry pi picos at the moment, by any chance would this still work on a RP2040 ZERO?
Board Life Status
Board startup date: April 23, 2017 12:45:48
OGX-Mini, Pico firmware for emulating Xbox (and other) controllers
in Hardware Mods
Posted
It's not pretty, but it'll do for now