By Johny white
So upped the game and went from doing soft mod and tsop to installing my first open xenium on 1.4 XBOX but the xbox is fraggin with trying to boot 3 times before giving up and staying off (Red/Green blinking).
Is there a diagram or way for me to check continuity from the motherboard and to the pins header to find which point not make contact either to the board it self or between the LPC rebulld board and the xbox board or trouble shoot this would be appricated???
EDIT: So before even the open xenium wasn't powering on, I tried to remove everything but it was pain so cleaned up and did the points again including the two I missed next to the header. Now the open xenium blinks red whenever the console tries to boot but quits after 3 attempts.
About to tsop my 1.2. i have the latest og xbox installer disc, my 80 wire ide cable is ready to go, soft mod is in place, I have my sata 2.5 inch adapter and 250 gig hdd to put in. I also have my xonductive paint for the tsop. I have seen all the tutoruals on yt that i can find but i am stuck with wondering if i should use evox or ind bios. This will be my first time tsop flashing and adding a bigger drive. I havent even seen whats on the ogxb disc yet. Is there a tutorial on ogxb installer? Or any other suggestions?
Thought I'd post a quick hello as I work my way through the huge overload of information on the internet with regards to modding. I believe I have a v1.4 or v1.5 as I have a Focus video chip. The internal condition is remarkable and shows how well I looked after it when younger - but now I want to be able to show my kids some of the games I played on the Xbox and before using an emulator so I'll be reading through guides etc on here
Board Life Status
Board startup date: April 23, 2017 12:45:48