Jump to content
OGXbox.com

HELP! xbox ntsc-j 1.0 aladdin xt2 hard mod instal - boot looping, freezing, not loading.


Jestamonkawa
 Share

Recommended Posts

Aplogies for the noobness here
My xbox will not load unleashx on the new hd often. it either takes along time to load or fails. it does not load evox in corner also. 

Xbox ntsc-j 1.0
2 tb WD Green
aladian xt2 hard mod instal
 

issues.
- doesn not load evox in conrer anymore after bios flash
- boot looping, freezing, not loading into unleash, going into red green flash after 3 boot attempts.
-if loads, often after a reboot will decide to 'take a break' boot loop into flashing lights, black screen.
-no EVOX logo with or without hd anymore ( this makes me think its a bios issue)
-loading hexen to install xmbc or try reflash bios is always unsuccessful.
-can load ogxbox just unsure what to instal.


Previous notes , install and before issues:

-Removed capacitor, installed chip, directed d0 to wrong point (plese see pic) still successfully launched EVOX.
-would not load hexen or new hd. redirected the d0 to proper point then had boot problems. starting logo would freeze.
-Reflowed aladdin pin headers.
-changed wiring back (picture - d0 point to ledhd - i did not clearly understand pdf install guide) hexen loaded.
-freezed once. flashed bios 480p an d couldnt get logo screen. reverted back. could load new hdd.
-installed ntsc package and got error on 'nodvd' (forgot this part kind of), still loaded into partioner.
-partioned hd using 947-1 method (2tbhd) rebooted but froze.
-reloaded hexen, reinstalled ntsc p[ackage succefully with no errors. 
-reformated drives again with 946 +1 method. 
-rebooted and got power boot loops and no evox logo.
-also got the issue LBA48 bios issues when checking reformat drives. however drives are formatted.

Thought it maybe hd issues or power issue or ide/sata issues but havetested with nad without hd and get same result. unless i leave the xbox to rest it wont reboot.
I can get into a succeful unleshx dash with hd partioned. it just doesnt run smooth or seem right.
Plesea see pics.

Ive burnt ogxbox disc to try and instal bios but unsure which one honestly. but this randomly loads .
I have a feeling ive done something to the modchip. iread that the bios on hexen for the chip was junk but have no idea how to instal a new bios now.
I hope someone can help

https://imgur.com/JB1rbXv
https://imgur.com/eTbE2sJ
https://imgur.com/P4YXvm5
https://imgur.com/piCzr6M
JB1rbXv.jpg

Edited by Jestamonkawa
Link to comment
Share on other sites

i would recommend you remove 1/4 - 1/3 of the solder from each joint on the LPC and clean it with isopropyl and a brush (tooth brush is good)

 What was the bios you flashed?

Now that you have the chip and new HDD you need to now install a OS/Dash board.

Load the install disk (OGXbox installer v.1.5.4) in the DVD drive and power cycle the Xbox, It should load and from that you can install a single dash of your choice (Me it's xbmc4gamers). Once it's installed a new dash you can then remove the DVD disk from the drive and power cycle the Xbox and it should boot fine.

 

Cheers

SS Dave


Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.
 

Link to comment
Share on other sites

Hi SS_Dave , thanks for your reply.

ive cleaned the solder up . i was able to run hexen before the crashes startand install unleashx. 
I think once i started to get problem was when i flashed the bios. I flashed it with 256k 1.0-1.5 X2.4981 F+G
i think i should have done the Evox M8 .i used true hexen 2020 and cant recall it being on it.
Once this the OS would take along time to start and down the bottom of the loading screen was "Xecuter2" 

the disc would rarely load also and gone was the EVOX logo.

I cannot boot thexbox with the HD now. it wont load hexen, OGXBOX or the HD. everthing is fine when i take the chip off however.

 

Link to comment
Share on other sites

10 hours ago, Jestamonkawa said:

I cannot boot the xbox with the HD now. it wont load hexen, OGXBOX or the HD. everthing is fine when i take the chip off however.

Can you upload a close up of the LPC?

 

Cheers

SS Dave


Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.