Jump to content

Board Life Status


Board startup date: April 23, 2017 12:45:48
  • Similar Content

    • By SS_Dave
      When your tring to solder to a circuit board and you damage it don't despair most stuff up's can be fixed
      If you have ripped the trace off the Xbox circuit board you need to STOP and try to relax, Walk away from the job for a minute or ten or more if neaded
       
      This is the trace that is damaged and need's to be repaired.
      This is a pic of a undamaged PCB same location.Please login or register to see this attachment.
      The red wire is what was suposed to happenPlease login or register to see this link.
       
      1st step Clean off the paint.
      Please login or register to see this link.
       
      I cheated and used a Glass fiber pen to do that but gentley scraping the track is ok you only nead to remove the paint.
      Please login or register to see this link. Please login or register to see this link.
       
      2nd Step Add flux to the board
      Please login or register to see this link.
       
      3rd Tin the trace
      Please login or register to see this link.
       
      4th Prep the wire you are going to use. I use wirewrap wire for a repair like this one as it's a single strand.
      Please login or register to see this link.
       
      5th Tin and trim the wire. I should have trimed it a bit shorter
      Please login or register to see this link.
       
      6th Lay the wire on the tinned trace and apply heat.
      Please login or register to see this link.
       
      7th Clean up the PCB
      Please login or register to see this link.
       
      Now rince and repeat for the other end.
      Once you have tested it and your happy a small dob of hot melt glue or even a dob(pin head sise) of super glue to stop the wire moving. Not on the solder joint say 5 to 10mm(1/4 inch) from the solder joint.
       
    • By Kura
      Hi everyone.
      What Xecuter MOD Chip is this?  I tried browsing the stickies but couldn't find a matching picture.  The only thing I remember is that this was solderless.
      Also, is there a diagram somewhere that I can solder it into the XBOX instead? 
      Thanks in advance.
      Please login or register to see this attachment.
    • By flux_no
      Hello,
      I have a V 1.0 Xbox that i bought modded back in 2003. around 2004 i updated the harddrive to a larger, and i did an update with Slayers disk(v2.4?)
      I cannot seem to be able to identify how the xbox was modded initialy. i have a "unknown" bios version. i cannot see a installed modchip. and rocky5 softmod disk does not give me any options to update the softmod.
      Would it seem that this could be an tsop fixed unit? from what i can remember, i do not think the unit was opened, so im unsure it its a tsop or softmod.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.