PV544 Posted May 14, 2018 Report Share Posted May 14, 2018 I just installed an aladin xt 4032 modchip on an 1.6 xbox. Everything works and went well. But I noticed after I turned off my xbox the red led on the modchip still stays on. Is this normal? Quote Link to comment Share on other sites More sharing options...
cOrPsE Posted May 15, 2018 Report Share Posted May 15, 2018 ive heard this is normal but you can disable it by soldering 2 points on the chip itself. not 100% sure Quote Link to comment Share on other sites More sharing options...
KaosEngineer Posted May 15, 2018 Report Share Posted May 15, 2018 (edited) Yes, for a v1.6 Xbox it will stay lit as the power line connected to the LPC header pin 6 is an always-on voltage source unlike the switched supply found on v1.0-1.5 consoles. Installation instructions should have mentioned removing pins 4 and 6 from the 2x6 header before installing it in the LPC Debug port. If you really want it to go off, remove pin 6 from the header and supply power from an alternate 5Vdc switch power source on the motherboard. For more info, see: http://xboxdevwiki.net/LPC_Debug_Port Not sure why he needs the flash drive mentioned at 6m04s. Probably for use with the older version of Hexen Shambles Edition instead use Hexen 2017 found in the downloads section here at ogXbox.com. Update: Yes, that was the reason, the BIOS file for v1.6 Xbox was older on the Hexen Shambles Edition disc than he wanted to use. Therefore, he downloaded additional software and copied it to the Xbox's HDD. The updated BIOS is already present on Hexen 2017 so those steps are not necessary. Edited May 15, 2018 by KaosEngineer 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.