Jump to content
  • Similar Content

    • By eAkGBG
      Ok I one of my xboxes just stopped working. I started desolder the pin header and my vellman vacuum pump ruined a few traces. So now I wonder where to solder the new wires.
       
       
      Please login or register to see this link. Please login or register to see this link.
      And should I cut the traces close to the solder points where it looks a little bit sketchy.
      I want to repair the visa for pin header and put some wires where it seems like I may have ruined the traces or what you call them.
       
      And also another question what is required for being able to download files in file section?
    • By ChiPPyX
      Just a quick question to throw out to the community. I just did my first 1.6 LPC rebuild using a rebuild PCB. I`ve done many LPC rebuilds the old school way, just running wires to the appropriate points, but I saw these boards, so I grabbed a few to try out.  I have mixed feelings about them. Yes, it was as simple as soldering the connections on the board to the point right next to them, and yes, they do look more professional, but did they save me any time, not really. With all the fiddling around trying to make sure all the points were exactly where they needed to be before tacking them in was a pain, and took way longer than if I had just run wires to where they needed to go.
       
      What is everyone elses  opinion and experiences with these LPC rebuild boards.

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.