jayjr1105 Posted October 22, 2020 Report Share Posted October 22, 2020 So I bought a cheapmod from ebay to try something different on a 1.6. Soldered in the rebuild board and installed the chip, adding the one wire from the lower LFRAM via to pin 3 on the LPC header. Won't boot from chip, and on top of that, installing the chip causes the LFRAM cut I made to then have continuity thus booting the stock TSOP chip. I would think I screwed something up but I slapped my openxenium chip I have in my parts drawer and it works fine. I've been looking at diagrams for 2 days now and can't figure it out. Does Pin 4 need removed from the pin header I soldered in? I've seen some guides that say Pin 4 can't be installed for this. Quote Link to comment Share on other sites More sharing options...
SS_Dave Posted October 22, 2020 Report Share Posted October 22, 2020 If you have cut the Lframe trace it will load the BIOS from the LPC port. You don't need to add any extra connections to it. Can you post a pic of the LPC rebuild? This is one of my LPC port rebuilds Where is has LFRAME to modchip you don't do this just cut the trace Cheers SS Dave Soft modding is like masturbating, It gets the job done but it's nothing like the real thing. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.