I just recently ressurected my old xbox, and upgraded it to a 2tb drive. I had to upgrade the bios on the chip in order to properly have the system see all the new space. I did so by using the hexen disc. So this worked, but now if i use the Xecutor bios, it takes a little over 10 seconds for it to get to the boot animation screen. If i use evox, its a little quicker, but not by that much. Anything i can do to increase the speed? On the old xecutor bios it was instantaneous.
Thanks in advance!
So there are some things I'm trying to figure out and having a hard time with, due to old, contradictory, or lack of info out there, and I'd greatly appreciate any thoughts. For reference, I have one each of v1.0 and v1.1, both with Xecuter 2.6 Lite chips.
If caps require replacement (not the clock cap), are there any known to have special requirements for ripple or ESR? I'm thinking regular polymer electrolytic caps from Rubycon or Nichicon would be fine?
Is there any reason to use FlashBIOS instead of XBlast? Assuming they're both stable, it looks like XBlast outright has more features.
Are the FlashBIOS/XBlast web flashing interfaces reasonably safe to use?
Without exploitable games or an Xbox/USB adapter, would the best way to TSOP flash a modchipped Xbox involve FTP backup of C&E, mod the backup with ndure, FTP it back to the Xbox, and turn off the modchip, then flash TSOP from the softmod dash?
Can Xblast be flashed to TSOP safely? I've seen posts arguing both ways.
If it can, could Xblast on TSOP be used to flash a modchip, if the chip is turned on after booting?
Board Life Status
Board startup date: April 23, 2017 12:45:48