Jump to content
OGXbox.com

Ogx360 Internal Install, Were To Put the Reciever?


ludvig82
 Share

Recommended Posts

I broke open the receiver case and took out the tiny circuit board, then I desoldered the USB cable, and soldered a new one to it that was just a few inches long... then I soldered a pair of wires to the 'pair' button, and connected them to a button I drilled out the back of the xbox, and then just used a piece of two-way tape to mount it to the top of the ogx360 xbox mount board I bought from tek nemesis.

I don't have any photos of the receiver mounted, but it's mounted to the top of the ogx360 plastic in this photo: https://i.imgur.com/6A9PZUe.jpg

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.