Jump to content
OGXbox.com

Rogue Ogre
 Share

Recommended Posts

Cutting the LFrame trace is up to you  I tend to cut the trace then not worry about the D0/LFrame wire from the chip.

The theory is that damage to the MCPX chip and or the Xyclops chip could happen if the Lframe is held low for to long, The Open Xenium mod chip will only pull the Lframe low for a short period when needed and the rest of the time it's not been controlled by the mod chip.

 

Cheers

SS Dave


Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

  • Thanks 1
Link to comment
Share on other sites

  • 2 years later...

I measured and the X3 doesn't release LFRAME like OpenXenium does. It sits at about 0.8V pulling 60mA from MCPX. The current from a dead short circuit is higher at 71mA.

This Xbox has been powered with the X3 installed for >1000 hours and no sign of damage yet. But it's still polite to release that strain.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.