TotalMoop Posted September 4, 2017 Report Share Posted September 4, 2017 I'm after a little assistance if you can. I've TSOP'd one of my units successfully for the first time so I'm rather happy. I'm now trying to upgrade the Hard Disk and I have the Hexen 2017 burned. I've installed the HDD and it's detected by Hexen at boot and formatted it all ok. Problem I have now is in the menu I'm trying to basically install a dash etc.. and its asking for a password. I'm entering the password as shown on the screen but it says password is wrong. I've attempted this a few times and I know I'm entering the password correctly but it's not accepted. Am I missing something or am I just dumb? Any help would be fantastic. 1 Quote Link to comment Share on other sites More sharing options...
Dave C. Posted September 4, 2017 Report Share Posted September 4, 2017 It should be AYBX and then start. Quote Link to comment Share on other sites More sharing options...
TotalMoop Posted September 4, 2017 Author Report Share Posted September 4, 2017 It should be AYBX and then start. I'm entering this but it fails Quote Link to comment Share on other sites More sharing options...
Dave C. Posted September 4, 2017 Report Share Posted September 4, 2017 What is the HeXEn path number? Quote Link to comment Share on other sites More sharing options...
MvZiC MaN Posted September 4, 2017 Report Share Posted September 4, 2017 You dont enter whats above. thats just telling you what buttons can be used in a password. Like Dave C said.. Press A,Y,B,X,Start and it should work just fine. 1 Quote Link to comment Share on other sites More sharing options...
Frank D'Agostino Posted September 4, 2017 Report Share Posted September 4, 2017 thanks guys didnt know the password as well.....i wrote it directly on the disk so i wont lose it 1 Quote Link to comment Share on other sites More sharing options...
KaosEngineer Posted September 5, 2017 Report Share Posted September 5, 2017 (edited) You can check the pass code and/or password set for menu options by FTP'ing a copy of UnleashX's config.xml file to your PC and open it in a text editor. They are saved in cleartext. <List Text="3.5.2. Clean C partition after TSOP flash" Sort="Off" Batch="True" Passcode="AYBX"> Edited September 5, 2017 by KaosEngineer 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.