I have a version 1.4 xbox that was TSOP modded with X2 4983.67 bios and 750gb IDE hard drive. I have flashed IND-5004.67 bios to it and now it does not see the G partition. I have tried to re-partition the drive to no avail, it will not see the G partition. If I boot the HEXEN 2018 disk it sees the G partition or if I re-flash the X2 bios it will also see the G partition. I am at a loss to what the problem I have is? Has anyone had this problem before. Thanks.
Hiya, just TSOPed my 1.2v Oxbox and put in a 160gb hdd. I split the F & G partitions 74ish gb each.
The F partition show 74ish gb but G partion is 0gb.
Used HeXEn 18 and the evox M8+ bios F+G, Both F & G values showed in XBpartitioner 1.3.
I successfully cloned my 100GB Maxtor to a Seagate 1TB drive using CHIMP. All my data, games, skins, etc were intact on the new drive. Then I went to use CHIMP to extend my partitions on my master drive (the Seagate) so it would recognize all 1TB but much to my chagrin when I rebooted I seemed to lose everything, including my skins, my emulators, and my Xbox games (there were about 100GB worth). The menu shows the categories and a barebones UnleashX skin but nothing inside them. How do I extend my partitions on my cloned drive so I get the full 1TB without losing my current UnleashX setup?