Search the Community

Hi there, I'm having some strange issues formatting SATA HDDs on a 1,6 Xbox with and Aladding xt +2 modchip. I have upgraded to a 1TB SATA drive with the SATA/IDE adaptor and the 80 wire cable. I just did this on a Xbox 1.0 and it worked just fine, but when I try on the 1.6 Xbox even though I try to write the partition at 927.7 GB it never shows up correctly after the reboot, the F drive is only 120GB and after many tries still cannot access the full amount of memory.. Tried a bunch of times, wondered if something was wrong with the drive (it was used but was working perfectly before I upgraded my computer to an SSD) so I went out and bought a brand new 2TB Seagate drive and I'm still having a ton of weirdness. When I try to make both partitions 927.7GB it still shows very strangely after a reboot. It shows (again) that the F drive is only 120GB but is showing the G drive at like over 1700 GBs. To my knowledge the largest size these partitions (with 64KB clusters) can be is 1024GB and anything over that will not work correctly. I kept messing with it and I can't get the two equal sized partitions no matter what. I have tried loading some games on and it seems to work (games load), and the memory seems to display correctly (minus the size of the game copied) after I copy a game. Should I bother worrying about this? The GBs do after all add up to pretty much 2TB... It just seems so strange because I was really pretty sure you can't have partitions over 1TB.. Also since I had no issues before on the 1.0 version I was thinking it could just be the Xbox somehow...? That seems wrong too though... Any clarification or suggestions would be super appreciated, thanks a bunch.