Search the Community
Showing results for tags 'pad'.
-
Hey all. Sorry if this has been posted, but I searched and couldn't really find anything. I have a 1.0 Xbox that was handed to me by a friend. He said he couldn't remember much about it, but that him and his kid tried to mod it a long time ago, and now it isn't working. Upon opening it, I found a pin header, no modchip, tsop points soldered, and the underside D0 pad ripped off. When I try to start the xbox, it cycles power 3 times then frags out. I'm assuming this is due mainly to the ripped D0 trace. I've tried repairing the trace, and bridging the two pads connected by the green line, but I can't seem to get the solder to stick. Is there any other way to repair this, or is this the only way? Relatively new to xbox modding so any tips would be appreciated. Thank you!
-
From what I can tell I butchered my r7d3 pad on the top of the 1.0 board. The bottom pad I did fine but I'm looking for the alternative now. I was looking at the pictures but just can't tell where to place the jumper now. Any help would be greatly appreciated. I linked a picture where I think I can and a picture of the board .Thanks !! From what I can tell I butchet d my r7d3 pad on the top of the 1.0 board. The bottom pad I did fine but I'm looking for the alternative now. I was looking at the pictures but just can't tell where to place the jumper now. Any help would be greatly appreciated. Thanks !! http://imgur.com/gallery/EDufPoH http://imgur.com/gallery/ZkWBmNA
-
Hi, i have a xbox 1.6 and I am replacing the Transistor but I accidentally took of 2 of the point for the Transistor. I really need help
- 1 reply
-
- knocked
- transistor
-
(and 2 more)
Tagged with:
Board Life Status
Board startup date: April 23, 2017 12:45:48