Search the Community
Showing results for tags 'lite'.
Found 5 results
I've installed some aladdin chips and wired them by soldering the "BT" point to the ground pin on the Xbox LPC. I figured that would be the same for the Duox2 lite chip, however I found a couple pictures online showing that the "BT" point on a Duox2 Gs chip (Dual Bank) was soldered to pin No. 9 of the LPC which is 3.3v. I just want to be sure that I'm soldering the "BT" to the right point on the LPC in order for it to always be powered on.
Evening all i've got 2 2.3b Lites and one 2.6. Anybody got the install diagrams as I can't seem to find them only the 2.3b+. Also with my LPC Rebuild kit they should work for 1.6's as long as I flash a working bios / Cromwell before installing? As I've ran out of Aladdins and have a few consoles in need of work.
Ok guys got an issue that is getting on my wick. Slapped a 2.3b Lite into a 1.6, used a clone LPC Rebuild Kit and proceeded to boot the console. D0 was connected to the board and ground was connected to the screw hole as usual. As soon as you put power to the console it will boot up then reset 2 times before FRAGGING. Only when D0 is connected and chip is off. With chip on with M8 1.6 Bios I can get a boot with Evo shield but it hangs after that and still turns on as soon as a power cord is plugged in. Front panel doesn't work at all. Remove the chip or D0, and it'll boot fine to the original softmod it came from. I've reworked it with my iron, even given it a hot air rework. Which point is most likely the culprit? Apologies on the lead free solder. Was using a friends over my own.
Hi. I just got an 1.6 Xbox with a DuoX2 Lite modchip. Can someone tell me how i can identify the bios flashed to the chip? And can i flash any bios to the chip with Hexen 2017? I bought the Xbox 10 yrs ago, so i am wondered if there would be any advantages for updating the bios to a newer one than the one thats on there now?
Board Life Status
Board startup date: April 23, 2017 12:45:48