Jump to content

Search the Community

Showing results for tags 'lifted'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Off Topic
    • New Member Introductions
    • Rumble Pit
    • Suggestion Box.
  • General Xbox Discussion
    • General Xbox Discussion
  • Original Xbox Modding Forum
    • Hardware Mods
    • Modchips
    • TSOP Flashing
    • Softmods
    • Repair
  • Xbox Case Modding
    • Case Mods
    • Lighting & Electrical Mods
  • Tutorials
    • Official Tutorials
    • Tutorial Submission
  • Software
    • Bios
    • Dashboards
    • Installation Disks
    • Applications
    • Games
    • Emulators
    • Homebrew
  • Xbox Collecting
    • Xbox Collection Showcase
  • Rare and Uncommon
    • Rare and Uncommon Xbox Hardware
    • Rare and Uncommon Xbox Software
  • Vendors
    • N64 Freak's Products
    • Barnito's Products
  • Development
    • Rocky5's Projects
  • Online Play
    • Game Night
  • Classifieds
    • Wanted
    • For Sale
  • Moderator Section
    • Moderator Back Room

Product Groups

  • Vendor Forum
  • Membership Subscriptions
  • Forum Ads

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me

Found 5 results

  1. Hi I'm currently doing a lpc rebuild on a 1.6 og xbox and I've managed to lift the trace on the trace near R7P4 does anyone know if theres somewhere else on the board I can pick this up? Thanks in advance.
  2. So I tried to Tsop my Original v1.0 Xbox and I think I lifted the traces. Now it tries to boot 3 times and then boots with flashing red and green LEDs. No audio/video. Is there anyway I can fix this? Alternate traces?
  3. My old eyes and lack of soldering skills has caused a problem. Plan was to TSOP a 1.0 Xbox. Top side bridge R7D3 went fine, but on the bottom of the board at R7R3 I burnt off the pad and the trace lifted up (bottom arrow). Can I solder a wire from the lifted trace to either the pad above it if I can get it to stick or the surface mount resistor above that pad (seen in pic)? Xbox is softmodded and still working. Maybe i should just quit while I am ahead lol
  4. Flowlance

    Lifted D0 Pad.

    So it seems like I attempted something I shouldn't when installing the aladdin chip. After soldering the wire to the pad, I did the wiggle test and it came loose, including the pad itself. The Xbox still seems to operate normally. Is it broken now? There's (obviously) no continuity on this trace now. Is there anywhere else I can solder D0 to ground?
  5. I lifted the pad on R7D1, attempting to enable TSOP. is there an alternative point?

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.