Search the Community

I have a modchip - currently unknown, I did it 10 years ago... Considering simplifying things and doing a tsop flash instead. So I know that the mod disables the onboard tsop (d0) so without enabling the chip, and disabling the mod, I cant access the tsop. But with the mod disabled, I cant boot unsigned, and therefore none of the flashing tools. So, am I correct is saying that once the mod is removed, I will need to soft mod, then flash? Is there another way? Switch on the d0 line maybe? boot to flasher, unplug mod (pin header install, and disconnect d0. is that even possible? Open to suggestions... Or.. I could just leave it alone...

I have recently discovered the stuff you can do with a wii2hdmi adapter, where you can chuck an xbox video connector to the back of it, and have the xbox og output over HDMI. I have just completed this mod, and found it simple enough. The xbox connector itself is however a bit fidly. I think there would be enough room under the DVD drive to mount a board and get hdmi output directly out of the back of the console, which would be alot cleaner in style and easier to use (without having a huge dongle sticking out of the back of the console). Now in order to get video signals, I figured I would just solder to the bottom of the motherboard where the video output connector is connected. I havnt had much play with this connector yet, and had planned to attempt to map it out to the connector., Does anyone have this already, which would make my life a little easier. I am also mindful of the fact that the wires inside the Faraday cage of the xbox would be liable to interference, it is part of my plan to perhaps use cat6 or similar shielded cable between the connections. Has anyone got any thoughts on this?