Search the Community
Showing results for tags 'ver'.
-
I am repairing xbox 1.4 for a friend. His box is having power supply issue. There is not enough volt to run the hard drive. I used external 12v/ 5v source to power the hard drive and the system boots up fine. The dvd disk drive is also working fine as it is connected to the xbox power supply. I took the xbox power supply out and didn't notice any bad caps or bad solder joints. With everything connected and powered up ,except for the power to the hard drive I get the following voltage values. Orange = 3.3V, Blue = 3.3V, Brown =3.3V, Red = 4.48V, and Yellow = 10.5V. I tried adjust the pot and that is max i can get for red and yellow wires. Which caps do I need replace for these two voltages ? or is there something else i can check? Thanks.
-
I have a version 1.4 console with a modchip installed due to a bad TSOP flash. I cannot seem to find the location of the A15 point to attempt the repair process. Can anyone point me to an image? Thanks.
-
Hello, I was flashing the xbox version of the tsop 256 kb with the plug, half finished the process and after this the screen is black. I installed the xchanger chip, the console works, is there any chance to repair the tsop? Regards
-
Hello, I have xbox ver 1.6, delta power supply gives 4,3 volt instead of 5v and the same drive hdd does not start. 12 volts is ok Capacitors have been replaced, but they are still the same. Do you have any idea what to check. The capacitor is 5v but on the output is already 4,3 volts
Board Life Status
Board startup date: April 23, 2017 12:45:48