Jump to content
OGXbox.com

Search the Community

Showing results for tags 'tgm600'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Rules
    • Why Can't I Download?
  • Subscribed Members Only
    • Subscribed Members Only
  • Off Topic
    • New Member Introductions
    • Rumble Pit
    • Suggestion Box.
  • General Xbox Discussion
    • General Xbox Discussion
  • Original Xbox Modding Forum
    • Hardware Mods
    • Modchips
    • TSOP Flashing
    • Softmods
    • Repair
  • Xbox Case Modding
    • Case Mods
    • Lighting & Electrical Mods
  • Tutorials
    • Official Tutorials
    • Tutorial Submission
  • Software
    • Bios
    • Dashboards
    • Installation Disks
    • Applications
    • Games
    • Emulators
    • Homebrew
  • Xbox Collecting
    • Xbox Collection Showcase
  • Rare and Uncommon
    • Rare and Uncommon Xbox Hardware
    • Rare and Uncommon Xbox Software
  • Vendors
    • N64 Freak's Products
    • Barnito's Products
  • Development
    • Rocky5's Projects
  • Online Play
    • Game Night
  • Classifieds
    • Wanted
    • For Sale
  • Moderator Section
    • Moderator Back Room

Product Groups

  • Vendor Forum
  • Membership Subscriptions
  • Forum Ads

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me

Found 3 results

  1. I bought a refurbished deck with a laser already assembled from ebay and also recapped the logic board 'correctly' with a cap kit from console5. I also replaced the dvd drive belt. I swapped out the deck assembly for the new one. I connected all of the ribbon cables and soldered the red and blue wires back. So dvd drive ejects very nicely and the cd that tested didn't get scratched or didn't stay stuck. The dvd drive emits a loud vibrating noise and I get the pop-up that says that the disc that I inserted is not an Xbox disc. Its a cd music disc that I inserted to test the dvd drive. What I suspect that I did wrong is that I applied too much lithium grease to the rails because the laser doesn't stay put in a single place anymore but it moves back and forth when I tilt the dvd drive. I also didn't pay attention to the laser position before I disassembled the dvd drive. I also don't know the correct level of the disc tray. The disc tray elevates up and down while the laser is reading a game. Its my first time repairing an Xbox dvd drive and I'm out of troubleshooting ideas. Edit: I just remembered that usually refurbished lasers have two pads bridged to protect the laser from being damaged by static. Well the two points were not bridged and there was a lot of burned flux residue too.
  2. Looking for two replacement lasers for Thomson TGM600 disc drives. I found some for about $45 shipped but you can get whole units for about the same. Anyone know where to get a better price?
  3. Video tutorial on how to pot tweak the Thomson TGM600 DVD drive found in the Original Xbox. It is recommended to have an ohm meter so you can see your adjustments before powering the drive back up.

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.