Search the Community
Showing results for tags 'lifted'.
-
Hi I'm currently doing a lpc rebuild on a 1.6 og xbox and I've managed to lift the trace on the trace near R7P4 does anyone know if theres somewhere else on the board I can pick this up? Thanks in advance.
-
Hi I wanted to upgrade the ram and I accedently lifted pin 55 acording to the datasheet it is CK is there a way to repair it?
-
So I tried to Tsop my Original v1.0 Xbox and I think I lifted the traces. Now it tries to boot 3 times and then boots with flashing red and green LEDs. No audio/video. Is there anyway I can fix this? Alternate traces?
-
My old eyes and lack of soldering skills has caused a problem. Plan was to TSOP a 1.0 Xbox. Top side bridge R7D3 went fine, but on the bottom of the board at R7R3 I burnt off the pad and the trace lifted up (bottom arrow). Can I solder a wire from the lifted trace to either the pad above it if I can get it to stick or the surface mount resistor above that pad (seen in pic)? Xbox is softmodded and still working. Maybe i should just quit while I am ahead lol
-
So it seems like I attempted something I shouldn't when installing the aladdin chip. After soldering the wire to the pad, I did the wiggle test and it came loose, including the pad itself. The Xbox still seems to operate normally. Is it broken now? There's (obviously) no continuity on this trace now. Is there anywhere else I can solder D0 to ground?
Board Life Status
Board startup date: April 23, 2017 12:45:48