Search the Community

I think I got lucky. I was looking for an Xbox below 1.6 to do a RAM upgrade on. I found one with the X3 front switch panel for the same price as any old Xbox without it. Just got it and it turns on. The chip turned out to be the newer CE version. But it's installed with the Xapt3r adapter. In https://command-tab.com/static/x3_ce_v10_v16.pdf there is an image of the standard kit: The parts that came with this Xbox are 1, 2, 3, 4 and 7. If I want to solder it I will need 9 also. That I can make myself from one of the scrap headers I have. But what is 8 and 10? My guess is that 10 is irrelevant. Is 8 for some drive activity led flashing? Is it available to buy somewhere?

When your tring to solder to a circuit board and you damage it don't despair most stuff up's can be fixed If you have ripped the trace off the Xbox circuit board you need to STOP and try to relax, Walk away from the job for a minute or ten or more if neaded This is the trace that is damaged and need's to be repaired. This is a pic of a undamaged PCB same location. The red wire is what was suposed to happen 1st step Clean off the paint. I cheated and used a Glass fiber pen to do that but gentley scraping the track is ok you only nead to remove the paint. 2nd Step Add flux to the board 3rd Tin the trace 4th Prep the wire you are going to use. I use wirewrap wire for a repair like this one as it's a single strand. 5th Tin and trim the wire. I should have trimed it a bit shorter 6th Lay the wire on the tinned trace and apply heat. 7th Clean up the PCB Now rince and repeat for the other end. Once you have tested it and your happy a small dob of hot melt glue or even a dob(pin head sise) of super glue to stop the wire moving. Not on the solder joint say 5 to 10mm(1/4 inch) from the solder joint.