Search the Community

Hello everyone, A while back I bought a couple of Xbox's 1.0 , 1.3 & a 1.6 . Fixed the first two up and running , now the last one turns on and off 3 times, then flashes red/green without video, previous owner says it had the error 06 but for me It doesn't give a video signal at all. A visual inspection of the board for any bulged capacitors shows no obvious faults, although I am aware that sometimes with an ESR meter (which i dont have) you can tell which is good and which is bad. I'm using a component cable and the V1.6 xbox is a PAL unit and the hard drive inside is definitely not stock 160GB storage and no hard mod is installed. A quick search gives me the idea that its probably the eeprom ( dead or corrupted ) if that is the case and assuming i have no backup as i do not know what the previous owner did to it, what should i do ? if not any ideas what should i check / do to troubleshoot the problem ? . I have a Rpi , arduino and an old eeprom universal flasher ( i will check if it supports the chips ). Oh and i have an Aladdin XT PLUS2 on hand if that would help , but kindly note that I have never used them before but if someone has a guide that would be appreciated as well. Best Regards SP

My 2005 XBox has an SDG-605F in it and it isn't reading discs. I cleaned the laser first. No go. Then, I adjusted the pot from 1247 down to around 560 in increments of about 100-150 at a time, and I've now given up. Is it possible that I just missed the point at which it will work? (That is, maybe I went to 720 from 850 but it would have worked at 785?) Any other ideas besides a wholesale swap-out? Thanks.

I recently got a green xbox and want to sell my old black xbox. I want to remove the 500GB sotmodded hard drive and replace it with the original 8GB. I know how to do that but I want to be able to use the 500GB drive in my Green xbox - how do I do this? I don't mind formatting the 500GB drive and starting afresh. I have an IDE PC if that's any use. Any help greatly appreciated