Jump to content
OGXbox.com

Listai

Members
  • Posts

    4
  • Joined

  • Last visited

Everything posted by Listai

  1. Thanks - although in my instance I have the rebuild board so I won’t need to run the wires. Do I need to solder in all of the pins to the rebuild board or just those in the wiring diagram?
  2. https://imgur.com/a/P7rnmgZ Hi everyone Yesterday I ran into an issue with my install - I have a 1.6 Xbox so I picked up an Aladdin XT and a rebuild board to make the job easier. Should be easy right? - apparently not as I stuffed it up. Basically I made the mistake of following a video where the rebuild board had a much larger space around the pins which allowed for quite a bit of solder to be flowed onto them - I followed those instructions and when I went to put my board on it didn't sit flush. So for whatever reason I decided to solder it in and see what happened. Naturally, it didn't work so I with armed with a lot of patience and a desoldering wick I managed to remove it without destroying any pads or traces - but I have another problem. I didn't remove the unnecessary pin headers for my 1.6 - will the chip still work? and do I need to solder all of the pins to the rebuild board (I'm confused about the plating corresponding to each of the pins) as I'm not sure if I can remove them as you can see from the image the solder has gone directly into the through hole and I don't have the means of removing it. Sorry if this is stupid but I barely managed to get the header off of the board (thankfully I ordered extras) I don't want to have to desolder another one of these. Thanks!
  3. Yup! From what I understand only 2.2 will be usable. It's getting hard to find 2TB 3.5" locally so I don't mind going a bit over
  4. Hi everyone! I picked up an xbox on FB marketplace for $20 as I couldn't resist as I'd always pined over the system back when I had a PS2 and GC in the early 00s. It wasn't in the best condition but I was determined to bring it back to its former glory. (That gunk in the grills is cigarette residue, the whole thing stunk to high heaven) Resolute in my mission I cracked it open and spent the better part of three hours cleaning it. The system itself is a 1.6 and all of the capacitors appear to be in good shape, the DVD tray wouldn't open at first but after I disassembled it and gave the belt a clean it now works like a charm. I've gone all in and have since ordered an Aladdin X2 modchip, an LPC rebuild board an 80 wire IDE cable and an IDE to Sata adapter. I'll be installing a 3TB HDD but I'm waiting on those components to come from China before I can start modding in earnest. I'm picking up an HD AV pack from a friend (who found it in his closet haha) and will be setting it up on my Sony PVM 20L2 (which sadly doesn't go above 480i) but I've picked up a few games over the years in the hopes that I'd eventually get the system to match! Anyway I missed out on this system as a kid so I'm looking forward to playing through the exclusives and the superior versions of PS2 games I loved (Burnout 3, Timesplitters etc) Thanks for reading!

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.