Jump to content
OGXbox.com

Uowjcnat

Members
  • Posts

    2
  • Joined

  • Last visited

Uowjcnat's Achievements

Newbie

Newbie (1/14)

  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

0

Reputation

  1. Thanks both (and thanks Kaos for replying to my Reddit post too ). I will give it a go. But can I just understand, is this likely to repair Christmas Lights (3 boot then FRAG?). I get that these are alternate ways to bridge the points to allow writing to a TSOP, but I wasn't aware this would solve the failed boots.
  2. I have an Xbox 1.0. I have an Xecuter 2.3B Lite+ mod chip (solderless with the pogo pins). It was working fine both with or without the mod chip, however I was keen on changing this to a TSOP as the d0 pogo pin can sometimes move out of position causing 3 boots then FRAG (Christmas Lights). Through a combination of bad skill, a bad iron, and bad solder; I managed to lift all of the solder pads in question (R7D3 and R7R3), plus one of the alternate solder points to R7D3. See the attached images of the board with the lifted pads highlighted. Now without a mod chip, it Christmas Lights. I wasn't expecting this as I thought lifting the solder pads wouldn't actually cause any issues (since they are all at the end of a trace rather than in the middle), just prevent me from performing a TSOP. With the mod chip it still works fine. Also strangely if the mod chip is switched to Disabled, it now boots the mod chip. My understanding is that this indicates there is something so screwed with the TSOP that it's booting from LPC even without d0 being grounded. I'm wondering if there is anything that can be done to repair the TSOP here? I have checked every trace I can in the vicinity with a multimeter and they all seem to have continuity. The R7D2 resistor seems to still be connected just fine. There are a few traces I can't really check as they go under the Nvidia chip. Or am I best to give up on the TSOP and get an Aladdin XT-4032?

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.