Sickk1

He sent it back. It's with me. Traces are all fine. I can try another chip for sure... No error Code. Just 3 times on/off, red/orange.

Hey guys, sold one of my chipped boxes, shipped her properly and she worked before, now we have the 3 times start and then red/orange flashing. All solderjoints were resoldered without and change in behaviour ... Any ideas ? Dead ?

I have 5 fragging XBOXes left, in which I already installed Modchip but that didn´t change a thing at all. I guess the boxes are just dead.

Ok thanks. So next Box problem. Error 13 & 16. Drive is locked. When I try to mount it the HDD in another Box as slave drive with Chimp I get serious I/O errors. I cannot boot from disc in the box , before booting I get the 16 or 13 Errors. I just chipped the box. Any ideas ?

Thank you. I always buy broken and neglected boxes and try to put new love into them.

Ok, so apparently this one has a bad RAM Chip and I haven´t got the hardware to replace it.

I bought 10 used xboxes and I would love to resurrect them. Maybe you could help out as the most sites are down that contain proper information about the OGXBOX. First one tries to boot 2 times, the red/orange flashing. I soldered a Aladdin XT on it, the Modchip flashes red as well, but no change in behaviour ... Any ideas ?

Cleaned everything. It really was the R3G3. The Resistor is fine , but anyhow the solderjoints got bad. Resoldered it, done. Box works. Thank you very much for your help !!!

I guess I got it. R3G3 measures with 50mOhm ?! Shouldn´t it be 10k ?

It´s a little weird. When I plug it in, it starts. When I hit the power button shorter than 3 seconds , nothing happens. When pushed more than 3 seconds, the box powers off but doesn´t react anyhow to the power button. Traces are corroded but they are still intact, no short circuit. Cleaned the whole board with alcohol.

I honestly don´t remember if the box was fine before. When I unplug the whole yellow cable it will still boot straight up. When I unplug the chip, still the same problem.

Yes, no short circuit.

Just checked. Only on the bottomside some residue from the clock capacitor. Definately some corrion on the traces at the bottom but all traces are 100% good for continuety. What else could it be ? Cleaned everything properly.

Awesome, will check that properly. Thank you very much...