Jump to content
OGXbox.com

evilduks

Members
  • Posts

    9
  • Joined

  • Last visited

Everything posted by evilduks

  1. I got 3.30V on pin 2 for both, alternating 3.3V to 2.5V on pin 1 for both, and alternating -4V to 2.5V off pin 3 for both R3V1 (pin 8 ) -3.8V - 1.8V R3V4 (pin 7) -6.1V - 2.5V R2G9 (pin 5) -2V - 1.7V R2G10 (pin 6) -2V - 1.7V Mainboard pins 5) -2.7V - 1.4V 6) -3V - 1.5V 7) -3.5V - -2.5V 8 ) -3V - 1.8V Similar numbers at the panel PCB connections. At the LED connections 5) -3.5V - 1.7V 6) -3.8V - 1.6V 7) -2.6V - -2.3V 8 ) -2.5V - 1.8V
  2. What are these near? I looked all over the board and couldn't find any labeled 2T
  3. I got these results POWSW 3.21V EJTSW 3.27V LEDR bounces around rapidly. Max is 3.18V, min is 0.12V. LEDG is doing the same as LEDR. Does this confirm your suspicion of a bad resistor before pin 7 of the button/LED board?
  4. I have a multimeter, but not much experience using it. What pin/s do I measure for the input or am I looking for the voltage difference between the output and ground. Sorry for all the questions, but we've gotten well outside of my areas of knowledge.
  5. Removed, cleaned, and reattached the chip, and removed and replaced the chip with a new ADM1032ARMZ with no change. I plan to take it to the only repair shop in town that agreed to look at it to try installing the spare ADM1032ARMZ I bought in case. Is there anything else I could be trying?
  6. I just removed and cleaned around the chip and there was some stuff underneath. Cleaned and replaced the chip to get the same error. Guess it's chip ordering time. Thanks for all your help.
  7. I think it is. It has only run at one speed with each of the errors regardless of the time left running or if it was fully in its case. I've cleaned the whole board with 91% isopropyl and a toothbrush and rinsed the area around the removed clock cap with the same. Do you think it's the ADM1032 at U6F1? My issue kind of matches up with this thread, but with an LED signal issue confusing me.
  8. How could that be causing no A/V out or the error? Or do you mean that it may be intending to flash orange, but one side's red LED isn't lighting?
  9. Tried to turn my Xbox on, it attempted to start 2 times and stayed on the 3rd with blinking orange/green lights at the same time (half orange, half green) and no A/V output. It is a 1.1 and I have removed the clock cap and jumped some trace rot that was causing it to turn on whenever it was plugged it, but the flashing and lack of A/V out persists. I have a reddit thread that has video of the error lights and shots of the main board and power board before clock cap and trace repairs. I am stumped. I cannot find that error anywhere and I don't have much experience diagnosing Xbox problems. Any help would be great.

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.