Jump to content
OGXbox.com

StealthAce113

Members
  • Posts

    1
  • Joined

  • Last visited

Everything posted by StealthAce113

  1. What you're describing is the standard "frag" it sounds like. I'm fighting with a 1.3 with similar boot issues myself, but those could be more-so related to me knocking a cap or two off on one of the chips I was attempting to ram upgrade a few weeks ago. From my experience so far and what you're describing, it sounds to me like it could be related to a broken D0 point (although I'm honestly not up on the TSOP method, I used modchips mainly) or even trace rot. I would inspect your D0 points visually, check all points with a multimeter, including the ground points on the pin header to D0 to ensure continuity. Then also go over your full power trace on the edge of the board with a microscope and confirm you have no trace rot occuring. If you do, you'll want to run some jumper wires to fix continuity. I had to fix some on the board I'm working on, that initially fixed my issues until I botched that ram chip install. Hopefully some of this helps.

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.