Plato

Looking for 720p patches that actually work properly. My console is 128mb ram modded. All links here are dead and really want a working Godfather patch. Cheers

I'm trying to find godfather patch

I need to know too

I think it was flaky glutch but I got lucky. I intended to flash Xblast to an old Duox2 but the chip wouldn't fit past the hdd connector. So I decided to do the install blind and test the xbox till it boots. I physically couldn't see any issues after the ram install and out of frustration with frags, I started pressing/holding eject and bam! The OS came up. FYI, console works a treat now.

Xbox rebooted between frags I think 3 times. Then it would stay on, all lights flashing. I just kept pressing then holding eject. OX eventually came up. I know the image doesn't prove much but I ran Xenium Ice in the whole time. Video link attached here. Shows xenium booting up with failure on ram chip 4. https://youtube.com/shorts/nTs6EYBQZwQ?feature=share

I recently did a ram upgrade using Xenium Ice by Nemesis with Xblast on one of the banks. I found that even with the console not booting with not all ram chips on board, I was able to get into the Xenium Menu by pressing and then holding eject after frag and launch the Xblast bios to do the ram tests. Obviously I did this till all 4 passed. Basically did this without any Xblast chip.

Is the folder named xboxhd?

Looking for m8plus hd+ titan udma5 64mb for xbox 1.4. F drive takes the rest.

Request thread be closed. Confirmed that resistors are required.

Hey all, I'm not new to the modding scene but querying the HD Plus install on a 1.6. I see that the flex cable is soldered to the resistor array network which is pre Xcalibur. Question is, are these resistors actually used in a HDplus install or can they be removed and flex soldered direct to board? There are 4 array resistors on the HDplus itself so it appears they are utilised rather than the one on the board. Reason I ask is that in one array on my board, one of the fours pins isn't having continuity whilst the rest have continuity at 33ohms. The bottom pad of the board linking to the pins can be soldered to the flex but I'm not sure if I need to run a 33ohm jumper resistor.

Just registered because I'm in a retro mood and decided to awaken my OgBox after years of not so fun gaming.

Very late to this discussion but I've been modding/repairing consoles for several years. In my experience, it's good practice to replace the thermal paste whenever the heat sinks have been upset or moved for whatever reason. As with the X360, you need to remove the X-clamps in order to get to some solder points and you really need to replace the paste as the heatsink has been disturbed. In short, if you've disturbed the heatsink, change the paste.