emiliano
Members-
Posts
14 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Store
Everything posted by emiliano
-
Good evening I'm trying to disable IGR on Cerbios bios as it uses the same combo as coinops to save games I use Cerbios tool but once the prepared bios is flashed, there is no difference Where am I wrong?
-
good morning everyone. I have several wii2hdmi that have the FS9299 chip but unfortunately the brightness is very low. I tested a wii2hdmi with 9288A chip and I have to say it's very good. Do you know where to find wii2hdmi with this chip? Thank you
- 11 replies
-
I've been trying for days but to no avail I need a power supply with 220v input in one with 127v input A delta DSPN-96AP-1 I have seen that they are practically identical to the ones that have turned into DSPN-96AP it does not have the simple jumper Everything else is identical I removed the transformer and made the jumper and I powered with 127v Unfortunately the power supply does not turn on Do you have any advice?
-
I'm creating my dragon image on a 4tb drive with bios cerbios I then filled the R and S partitions with the full set of xbox games and I am making the various connections with xbe shortcut maker2.0 from the dragon folder located in partition F Unfortunately, all links don't work As if the software fails to manage the 2 new partitions Are there any solutions at the moment?
-
I would like to retouch the crazy asylum project as I would like to create a new hole for the position of the quartz, arrange the 3 rgb pads as they are milled too much and remove the cut on the lower gerbers of the 3 audio and 5v pads Does anyone have the initial project? Editing directly from gerbers is problematic
- 11 replies
-
better raise it with the wire cutters remain spikes that I can cut a track that passes right under them
- 11 replies
-
- 11 replies
-
- 11 replies
-
today i got this wii2hdmi new models. I had to redesign the 3d plate. what do you think? it is a little longer so it is easier to weld at the back. the only shrewdness is to raise the quartz otherwise it touches
- 11 replies
-
yes I know how. i use pcbs found on dirtypcbs better than crazy asylum ones more refined. indeed if you have the gerber of dirtypcbs you would be doing me a great favor
- 11 replies
-
I wanted to get it earlier to make it easier to solder the plate. anyway I tried. taking the signal first the screen remains black
- 11 replies
-
good evening Request If I take the component signals before the 0.27ohm resistors to install an internal wii2hdmi, do you think it can be a problem? Would it still work? Anyway tomorrow I'll try
- 11 replies
Board Life Status
Board startup date: April 23, 2017 12:45:48