xboxn00b

I think I am going to move the switch (black cables) inside the case so it doesn't get bumped. I have never needed to change it and I can't foresee me needing to again once it is all working. I have also removed the ribbon cable it had on the back to connect to an external port, which I never used (black port).

Hopefully this is a bit clearer. Hesitant to take the board out until I am ready to replace the parts to avoid any further damage.

Hi Dave, I disconnected everything and the same thing occurs - reboots 3 times and then FRAG. I have taken a closer up on the 3 caps that I think that need to be replaced. Is this a reputable source for them? - https://console5.com/store/microsoft-xbox-original-cap-kit.html

Thanks team. I will do some research and see if I am confident I can do it. I have all the equipment Dave mentioned from my Raspberry Pi tinkering, but my soldering has been limited to connecting game pad PCBs to Pi boards. My soldering wasn't great but it did the job. Should I stick with the Xecutor Pro board or try to swap it out for a Xenium?

How hard would replacing the caps be for a soldering noob though?

Not sure if this is relevant, but the capacitors/power unit all looks clean.

Good afternoon team, I recently found my OG XBOX which I can't remember the last time I actually powered it on (possibly up to 10 years). I originally bought it to play emulators on back in the day and after watching some youtube clips on how the emulators have kept being updated, thought I would try to get it working again for the lols. I didn't have any cables anymore so orders some cheap 3rd party ones and a controller off of eBay. I held my breath and pressed the power button for the first time in forever... and to my surprise it tried to boot up, but then gave me the reboot x 3 and started to display the FRAG. From what I can tell the chip is an Xecutor Pro 2.x I tried various switch combinations but to no avail. I have also disconnected and reseated all the cables I could see, but to no avail. I have no way of determining if the HDD has failed (it is IDE and I no longer have any IDE tools/plugs), but if I remove the drive and try to power the xbox on without it, it still follows the same process (reboot x3, then FRAG), so I do not think that is the problem. I can only assume there is something wrong with the bios or the board itself. My question is: is this salvagable? Am I able to get it working again? I got a friend to mod the xbox back in the day so my technical skills with it are lacking. From the googling I did, apparently a XeniumICE mod chip might be able to bring it back to life, but I am not sure if that is compatible with the mod chip I already have (could they be swapped out?) and I am a noob at best at soldering (and I recall the Xecuter being difficult to solder). I have attached some photos of the machine and can give more information if needed. The searching on here seems to mention that the bios might need to be reflashed etc but this was one of the chips that needed a printer cable to connect ot it and reflash, so that might be an obsolete option now. Thanks in advance.