Abittencookie

Haha good to know it's not too bad and yeah I was practicing on an old board doing fine for the bottom fine then this happened lol. Thanks again man

Perfect, it looks like I still can so I'll give it a shot. Board looked a little rough in there haha. Thanks !

So was I correct in the jumper spot then? My pads seem gone if you check those pictures

From what I can tell I butchered my r7d3 pad on the top of the 1.0 board. The bottom pad I did fine but I'm looking for the alternative now. I was looking at the pictures but just can't tell where to place the jumper now. Any help would be greatly appreciated. I linked a picture where I think I can and a picture of the board .Thanks !! From what I can tell I butchet d my r7d3 pad on the top of the 1.0 board. The bottom pad I did fine but I'm looking for the alternative now. I was looking at the pictures but just can't tell where to place the jumper now. Any help would be greatly appreciated. Thanks !! http://imgur.com/gallery/EDufPoH http://imgur.com/gallery/ZkWBmNA