hideehoo

Are the save file for this method available somewhere? Thanks

Pulled an ADM1032 off another fatally damaged board and this one fired right after replacement. So it looks the chip was bad even though visually there was no apparent issues.

Got a version 1.0 that is flashing orange (high temp) immediately after power up. ADM1032 chip looks good and meters out fine for power and I2C bus connections, but when I throw a logic analyzer on the bus, it never returns a READ response. 1.958481000000000,I2C,Setup Write to ['152'] + NAK 1.958792500000000,I2C,Setup Write to ['152'] + NAK 1.959192000000000,I2C,Setup Write to ['152'] + NAK 1.959548000000000,I2C,Setup Write to ['152'] + NAK 1.960861500000000,I2C,Setup Write to ['152'] + NAK Compare that to a "good" box I have than returns both MB and CPU temps over and over during the boot process. 1.069577000000000,I2C,Setup Write to ['152'] + ACK 1.069807500000000,I2C,'1' + ACK 1.070072000000000,I2C,Setup Read to ['153'] + ACK 1.070300500000000,I2C,'24' + NAK 1.070584000000000,I2C,Setup Write to ['152'] + ACK 1.070815000000000,I2C,'0' + ACK 1.071078000000000,I2C,Setup Read to ['153'] + ACK 1.071306000000000,I2C,'23' + NAK Before I replace it, any other thoughts? Clock cap was still on the board, but actually looked pretty good (minimal leakage), and the ADM1032 and surrounding area has been cleaned several times with IPA.