Jump to content
OGXbox.com

exboxer

Members
  • Posts

    1
  • Joined

  • Last visited

exboxer's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. From the manual: The Matrix has 4 user modes and 1 programming mode, the programming mode is automatically entered when the Matrix is attached to the supplied programming device. This mode is independent of the dip switches. It is recommended to set the desired mode whilst in mode 1 (green LED flashing) and the power to the console on. This will insure that the Matrix remains aligned while you change mode. The mode change will only take effect on the next power up. Mode 1 (Dip switch 1 & 2 ON)(LED: Red or Green flashing) Test/Disable This mode is primarily used for the alignment of the Matrix during installation. It may also be used to fully disable the Matrix while in circuit. Mode 2 (Dip switch 1 OFF, 2 ON) (LED: Green) Always On This mode enables the Matrix to take over the original bios at all times. Mode 3 (Dip switch 1 ON, 2 OFF) (LED: Green =Matrix, Red =Original) Swap mode This mode works as follows: On every power up the Matrix “bios” is loaded indicated by the Green LED. To switch to the original bios the user must load a game and then press eject, at this time the LED will turn Red indicating that the original bios is active. To switch back the user may either turn off and on the console or repeat the above. Mode 4 (Dip switch 1 OFF & 2 OFF) (LED: Orange flashing) Write enable In this mode the Matrix is always active but has the ability to be flash updated via DVD Rom. We do not recommend you leave this mode on permanently, a bad update of the flash will mean you will have to reprogram the Matrix via the programmer. I don't see why you would need to reprogram the chip. It is most likely not aligned or not in the right mode. Matrix_ManualV1.1.pdf

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.