Paolo Mancuso
-
Posts
50 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Store
Everything posted by Paolo Mancuso
-
I tried with powered on console and I've 5 volts....sorry I'm not an electrician..and maybe I've not enough skill...but I modified a lot of console...without issue
-
This is a test there are no 5 volt...xbox is unplugged from power...is not
-
350 and I added more Flux..I think that I've to improve the technique for the second adapter...
-
Now I checked the rgb and 3 pin under motherboard, of course the adapter is a new one
-
-
I tested, xbox is unplugged powered off, and the value on multimeter is 0. So I've to remove the adapter....right and solder back again..but there is some tips that I can use to check it before solder everithink, some check list to eliminate the possible mistakes?
-
This is my personal version of cap...longer on bottom and shorter on top...
-
Have you the Gerber file of 2.1 adapter...maybe the version that I have could be the cause of this kind of problem and also I don't have 1.6 version of pcb...
-
It's 1.4 but I checked all the points with the points under the motherboard...now I'm not in my home...so I cannot check..
-
I'll test it, thanks..
-
How Can I test it? With multimeter...ofcourse but where I've to put the pointer...?
-
When I Bridged the two point stop flashing...but no video...
-
No, and I checked every point of the two adapters with the point on motherboard...with bridge multimeter function...
-
In the 1.4 No Vdeo No sound...:( and when I attached the first time the hdi cable the ring was blinking gree and yellow like cable not atached, but i was forgotted to bridge the pin under the avip...I was thinking this the reason to not work...so i bridged the pin, but the issue remain...
-
Ehy Dave, fixed!!! Now I've no noise...thanks.. I've another one to make attention, becasue with hdmi adapter has no signal it's a 1.4...
-
If you need it.. i found..;) xbox2hdmi.stl
-
I've another request Have you the stl of the cap of hdmi case? Because I lost it, and I want to make some changes...
-
Thanks I'll try hdmi fix with wire, stay tuned.
-
Ah can you give me the stl file for the cover of hdmi board? THanks....;)
-
Which part of bottom motherboard can I use to put the wire? I'll try soon..;)
-
But if the mesurment is Zero, what could be the problem?
-
Ok thanks Dave..
-
-
I've multimeter...but I don't how to measure it the console could be switched on? Can you explain me? Thanks Dave...
-
I can say that the noise in also on the xbmc4gamers dash....
Board Life Status
Board startup date: April 23, 2017 12:45:48